Advanced Global Technology QSP-660 User Manual
Advanced Technology Video, Inc.
QSP-660: Instructions for Basic Operation and Installation
Page 4
G
ETTING
S
TARTED
The above diagram shows the typical 4-camera installation for the QSP-660. Up to four cameras can be
connected to the real time quad using the back panel connectors.
connected to the real time quad using the back panel connectors.
Note: The VCR and monitor connections must be as shown above for proper operation.
Installation Steps
The following steps should be followed to ensure proper connection and set up of your QSP-660.
A diagram showing the overall connection configuration of the QSP-660 is shown above.
The installation steps are:
A diagram showing the overall connection configuration of the QSP-660 is shown above.
The installation steps are:
1.
Connect your cameras, monitor, and VCR (if recording is necessary) to the QSP-660. Refer to
the “Back Panel Connections” and “Video Line Termination Switches” section on page 5 for
proper connections and switch settings for your particular installation.
the “Back Panel Connections” and “Video Line Termination Switches” section on page 5 for
proper connections and switch settings for your particular installation.
2.
Power up the QSP-660, then enter the QSP-660 set up menus by pressing and holding the
DISPLAY button for approximately 3 seconds. Refer to the Set Up menus section of the
manual starting on page 8. Set the current time and date in the QSP-660 using the Set
Time/Date menu.
DISPLAY button for approximately 3 seconds. Refer to the Set Up menus section of the
manual starting on page 8. Set the current time and date in the QSP-660 using the Set
Time/Date menu.
3.
Exit the QSP-660 menus by pressing the DISPLAY button to exit each menu and finally the
menu system.
menu system.
Alarm Inputs
Camera
Camera
10K
(Optional)
Alarm Out
QSP-660
Configuration
VIDEO OUT
VCR-IN
Camera
Camera
VCR OUT
VCR
OUT
IN
Optional for VCR
recording
changes
Monitor