Acer L460 User Manual

47

The following table describes the parameters found in this menu. 

Init Display 

First

Initialize the AGP video display before initializing 

any other display device on the system. Thus the 

AGP display becomes the primary display. 

Reset

Configuration

Data

Normally, you leave this field Disabled. Select 

Enabled to reset Extended System Configuration 

Data (ESCD) when you exit Setup if you have 

installed a new add-on and the system 

reconfiguration has caused such a serious conflict 

that the operating system cannot boot 

[Enabled],

[Disabled]

Resources

Controlled By 

This item allows user to assign PnP resource (I/O 

address, IRQ&DMA channels) for Plug and Play 

compatible devices automatically or manually 

[Auto]

[Manual]

IRQ Resources  When resource are controlled by manually, assign 

each system interrupt a type , depending on the type 

of device using the interrupt.   

Option:

[PCI Device]: Assign this IRQ for PCI device. 

[Reserved]: Reserve this IRQ for other device. 

[Press Enter] 

PCI/VGA

Palette Snoop 

This option is only very rarely needed. It should be 

left at “Disabled” unless a video device specifically 

requires the setting enabled upon installation. 

[Disabled],

[Enabled]

Maximum

Payload Size 

This field displays maximum payload size of the 

system

[128-4096]

PCI 1/2 IRQ 

Assignment

This item allows user to assign PCI IRQ for device 

[Auto], [3] , 

[4] , [5] , [6] , 

[7], [10] , 

[11] , [12] , 

[14] , [15]