DMP Electronics Inc. Network Router LT-0424 User Manual

PROGRAMMING INSTRUCTIONS

Ether-Com

TM

LT-0424 (1/99)

2841 E. Industrial Drive  Springfield, MO  65802-6310  800-641-4282

Description

The Ether-Com

TM

 Single Port Router allows a DMP 1912XR, XR200 or XR200-485 Command Processor

TM

 panel to

communicate to a DMP SCS-1 Receiver using an existing Ethernet network. The router operates as an interface
between the panel and the network.

What’s needed

    Additional equipment needed to program the Ether-Com

TM

:

    386 or better laptop or PC

Windows

TM

 95 or 3.1 with a communication software package such as Hyperterminal

TM

  or Terminal

TM

    DMP Model 396 programming cable
    10BaseT Ethernet cable

Configuration for use with a DMP 462N or 862N

The following configuration is designed for applications where the Ether-Com

TM

  server is used as the interface

between the DMP 462N or 862N  Network Interface Card on a 1912XR/XR200/XR200-485 panel and an ethernet
network.

1912XR/862N orXR200/462N

Configure the communication software package on your laptop or PC for  9600 baud, 8 bits, no parity 1 stop bit and
no flow control.  Connect the DMP Model 396 programming cable to the  COM port on your laptop  or PC that you
configured in your communication software. Connect the other end of the Model 396 programming cable to the
Ether-Com

TM 

 connector supplied with the unit.

DO NOT CONNECT the Ether-Com

TM

 to an Ethernet network at this point. Apply power to the unit. If the unit

passes its power-up diagnostics the following message should be displayed:

Ethernet Address:   00-80-a3-0f-4a-d4            Internet Address: 10.17.39.1

Flash Rom Version   2.0 (May 12, 1998)

Flash Version:          3.5/1   (970707)

Current Diagnostics report:

      NVR Config:              Normal                   Ram Size:        256 KB

      CPU Speed:               10 MHz                    Gate Array:      Rev 2

      Flash Version:          3.5/1 (970707)       Ethernet: None

      Errors:                      Network

No network was detected.  Press a key within

10 seconds to access bootmode commands>

Press the Return key to access the Boot> prompt.

Enter the following commands at the Boot> prompt:

 1.      

CHANGE BOOTP DISABLED

 2.      

CHANGE DHCP DISABLED