Blodgett KTT-E Series User Manual

5

Immediately after unpacking, check for possible shipping damage.  If the kettle is found to be
damaged, save the packaging materials and contact the carrier within 15 days of delivery.

1.  The kettle must be installed in accordance with:

2.  State and/or local codes.

3.  In the USA, the National Electrical Code, ANSI/NFPA-70 (latest edition).  In Canada, the

Canadian Electrical Code, Part 1, CSA Standard C22.1 (latest edition).

4.  Position appliance on counter allowing sufficient rear clearance from wall to tilt freely and

completely without obstruction.

5.  Mark four corner locations of appliance base.

6.  Remove appliance from counter and locate position of 4 holes as per Figure 1.  Drill four

7/16" diameter holes.

7.  Apply a continuous bead of Silastic or other equivalent sealant along the complete perimeter

edge of the appliance base.

8.  Use 5/16-18 Hex Cap Screws with suitable flat washers to bolt down.  Screw length must be

1-1/4 long plus counter top thickness.

9.  Wipe off excess sealant.

10. A control box with power supply equivalent to Electrical Rating of appliance should be

located conveniently nearby.