Brother MFCP-2000 Owner's Manual

CHAPTER 3 PRINT

3-3

This 

 will be used for the following purpose depending on the

situation.

If you press the 

 during printing, the machine immediately stops

printing and ejects the paper.

If the machine is in sleep mode, pressing the 

 wakes it up into the

ready state.

If the 

 lamp is on, press the 

. The machine prints any data

remaining in  memory: this operation is called “Form Feed.”

If an error occurs, the machine will recover from some errors
automatically. If the error does not clear automatically,  press the 

to clear the error and continue machine operation.

The machine has the following useful features:

When the machine does not receive data for a certain period of time
(time-out), it enters sleep mode. Sleep mode acts as though the machine
was turned off. The default time-out is 5 minutes. While the machine is in
sleep mode, all the 

 are off and it is as if it was turned off, but the

machine can still receive data from the computer. Receiving a print file or
document automatically wakes up the machine to start printing. Pressing
the 

 also wakes up the machine.

✒ Note



When the machine goes into sleep mode, the fan will not stop until the
machine engine has cooled down.



Sleep mode allows the print engine to cool, so the temperature of your
room and how long the machine has been in sleep mode affects the
warm-up time. This warm-up time can take up to 30 seconds. The

 lamp blinks to indicate that the machine is warming up.



You can change the time out for the sleep mode with the supplied
printer driver or Remote Printer Console program. Refer to the Help
section in the printer driver or RPC program for more information
about the sleep mode setting.