Bosch HES7052U Quick Setup Guide

English 5

For installations other than those in Canada, in stall the strain relief and connect 
the range cord (or wire conductors) as described in the following steps. 

* Varies by location. Refer to local electric code.

•

Tape warming drawer or storage drawer shut to keep it from opening while 
installing the range.

•

During installation, place a portion of the box or a piece of cloth under the 
range to protect floors.

•

To make range lighter and easier to handle, remove door (see instructions in 
Use and Care manual).

We strongly recommend the installation of a ventilation hood above this range. 
For most kitchens a certified hood rating of not less than 300 CFM is recom-
mended. The range hood must be installed according to instructions furnished 
with the hood.

Seal any holes in the walls or floor. Remove any obstructions (extra electrical or 
gas connections, etc.) so that range will rest against wall properly.

Place range in front of cabinets where it is to be installed. Remove any packaging.

 The strain relief provided with your range cord must be 

properly installed. 

Place strain relief in knockout below terminal block (See Figure 4). Feed range 
cord through hole and strain relief up to terminal block. Allow for slack in the cord 
between the strain relief and terminal block. Once cord length/ slack has been 
adjusted, attach strain relief per instructions included with strain relief. 

Tip: The knockout panel (below the terminal block) can be removed from the 
range to install the strain relief: Remove panel from range, install strain relief in 
panel and reattach. DO NOT remove entire range back panel.

Check data plate for kW rating. Reference kW rating in table to determine amper-
age requirements.

At 120/240 Volts:

At 120/208 Volts:

US Models:

Canadian Models:

12.3

9.2

40 or 50*

12.6

9.5

40 or 50*

50

13.5

10.2

50