Bosch Appliances Home Security System FMR-7036 User Manual

FMR-7036 | Fire Annunciator Keypad | 1.0 

Notice 

. 

 

Bosch Security Systems, Inc. | 9/08 | F01U010584-01 

3

1.0 Notice 

These instructions cover the installation of the Bosch 
Security Systems, Inc. FMR-7036 Fire Annunciator 
Keypad in a fire system supervised by a Bosch FPD-
7024 Fire Alarm Control/Communicator. 

 

Install, test and maintain the FMR-7036 according to 
these instructions, NFPA 72, local codes, and the 
authority having jurisdiction. Failure to follow these 
instructions may result in failure of the device to 
operate properly. Bosch Security Systems, Inc. is not 
responsible for improperly installed, tested or 
maintained devices. 

 

 

NFPA 72 requires a complete system-wide 
functional test be performed following any 
modifications, repair, upgrades, or 
adjustments made to the system’s 
components, hardware, wiring, 
programming, and software/firmware. 

 

 

These instructions contain procedures to 
follow in order to avoid personal injury and 
damage to equipment. 

2.0 Device 

Description 

The FMR-7036 is a four-wire LCD annunciator 
keypad for the FPD-7024 Fire Alarm 
Control/Communicator. It may be surface mounted 
to a standard three-gang box or with the provided 
mounting backplate. 

Figure 1: 

FMR-7036 Fire Annunciator Keypad 

FIRE SYSTEM ANNUNCIATOR

3.0

  Installing the Reference 

Card 

A quick-reference card is provided and needs to be 
installed in the receiving slot indicated in Figure 2. 
The slot is located behind the mounting base 
holding the circuit board. 

 

Install the reference card before securing 
the keypad. 

 

Figure 2: 

Reference Card Installation  

FMR-7036 Reference Card

Slide reference guide between keypad holding tabs.

1

2

4.0

  Mounting the FMR-7036 

The keypad should be mounted no higher than 
shoulder height of the shortest person using the 
system. 

Remove the keypad’s cover. 

Insert a small flathead screwdriver in each slot at the 
bottom of the base. Press up, and pull the cover off. 

4.1 Surface 

Mounting 

Use the base as a template to mark the location of 
the mounting holes (refer to Figure 3 on page 4 for 
mounting hole location). 

Provide an opening in the mounting surface for the 
wiring. 

Pre-start the mounting screws. 

Do not secure the base at this point. 

4.2 

Electrical Box Mounting 

Refer to Figure 3 on page 4 for the location of the 
mounting holes.