Bosch Appliances Computer Monitor UML-273-90 User Manual

This chapter outlines the procedures to install the monitor. A
qualified service person should install the monitor and adhere to
all local codes.

To prevent overheating, ensure that the ventilation openings on
the rear of the monitor are not covered.

The Bosch Flat Panel CCTV monitors are delivered with a 3-pole
US-style power cord and a 3-pole Euro-style power cord. Use the
US-style power cord where 120 VAC, 60 Hz power is available;
use the Euro-style power cord where 230 VAC, 50 Hz power is
available. The monitor automatically adjusts to either power
input voltage.

There is one (1) BNC connector located on the rear panel of the
monitor for composite video input and one (1) BNC connector
for composite video output (Refer to Rear Panels, page 20).
Note: All video inputs are passive loop-through. The impedance
is automatically set to 75 ohm by the input of the signal on the
input connector, while operating in a single connection mode
(refer to , page 35). If a cable is also connected to the output
connector, the video signal can be passed on to another monitor
connected to it via the passive loop-through function. Up to
three (3) monitors may be connected in this manner (refer to ,
page 35).
Note: To select AV1, press VIDEO SOURCE/ENTER, and then
press the Up or Down arrow button, located on the front of the
monitor.

Bosch High Performance
HD LED Monitors

Installing the Monitor | en

Bosch Security Systems, Inc.

Installation Manual

2013.02 | 3.0 |