Bosch SMV50C00GB Instruction Manual

As soon as the rinse-aid refill indicator )"
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
–

Open the dispenser 1j by pressing
and lifting the plate on the cover.

–

Carefully pour rinse aid up to the max.
mark in the filler opening.

–

Close cover until it clicks shut.

–

To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.

Setting amount of rinse aid

The amount of rinse aid dispensed can be
set in 4 stages. Accordingly 0, 1, 2 or 3
displays are lit (see water hardness table).
Factory setting: 2.
Do not change the amount of rinse aid
unless streaks (select lower setting) or
water stains (select higher setting) are left
on the utensils.
–

Open the door.

–

Switch on ON/OFF switch (.

–

Hold down button > P and press
START button h until the End display

` and salt refill indicator )* flash.

–

Release buttons.

–

Keep pressing button > P until the
rinse aid refill indicator )" flashes.
The rinse aid refill indicator )" flashes
and the displays # and + are lit
(= Setting 2).

To change the setting,
–

Press the button < H until the
required setting has been selected.

–

Press START button h.
The displays ` and )" go out. The
selected setting is saved.

–

Close the door.

Switching off rinse-aid refill
indicator

If the rinse-aid refill indicator )" is
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
–

Proceed as described under “Setting
amount of rinse aid” and select
setting 0.

The rinse aid refill indicator )" is now
switched off.

Rinse aid %

PD[