Bosch PCH 612 DAU User Manual
6
This installation must conform with the following:
•
Manufacturer’s Installation instructions
•
Local Gas Fitting Regulations
•
Municipal Building Codes,
•
AGA Installation Code for Gas Burning Appli-
ances. (AS 5601/AG 601)
•
S.A.A. Wiring Code
•
Local Electrical Regulations
•
Any other statutory regulations
These built-in hobs are intended to be inserted in a
benchtop cutout.
Only an authorised person should connect the appli-
Only an authorised person should connect the appli-
ance.
Installation dimensions are shown in Fig.1
Installation dimensions are shown in Fig.1
Before connecting the unit, check whether the local
connection conditions (type of gas) are compatible
with the unit’s settings. Observe any special condi-
tions imposed by local suppliers (utilities). The specifi-
cations of this cooktop are stated on the data label
located on the bottom of the cooktop base.
Installation
1
11
Depress control knob and turn anti-clockwise to ‘High
flame’ position. Hold the knob down for a few sec-
onds until the flame ignites. Keep control knob de-
pressed for a few seconds to activate the flame failure
device. If ignition fails, depress knob again and wait
for ignition. Turn anti-clockwise to set the flame to the
desired intensity.
All burners are fitted with a flame failure device which
All burners are fitted with a flame failure device which
shuts off the gas supply if the flame extinguishes for
any reason. To re-ignite, wait 30 seconds for any
unburnt gas to disperse before repeating the ignition
procedure described above.
To turn off the gas supply to a burner turn the control
To turn off the gas supply to a burner turn the control
knob clockwise to the ‘OFF’ position. (Refer Fig. 14)
The control knob is used to adjust the flame of the gas
burner.
‘Low flame’ graphic = lowest output
‘High flame’ graphic = highest output
‘Low flame’ graphic = lowest output
‘High flame’ graphic = highest output
Operating instructions
1. Medium burner
2. Medium burner
2. Medium burner
3. Wok burner
5. Small burner
5. Small burner
Burner ignition &
control
Preparing to install
Burner locations
13
14