Bosch MUM6N10UC Owner's Manual

Page of 88
21
4. Place the blender with cover on the 
high-speed drive of the power unit. 
Note the mark on the appliance and 
on the blender. Turn the blender 
counterclockwise with a slight 
downward pressure until the jar is 
firmly seated, see figure 13.
Figure 13
Placing Blender into 
Operation
Normally when blending, the blender jar 
should be filled with the entire amount of 
material to be blended, if possible, before 
switching the appliance on. The cover and 
cover closure should always be in place 
after filling the blender jar and before 
switching the power unit to On.
Any subsequent additions to the blended 
material should be made through the cover 
opening, see figure 14.
For solids and/or granular material, remove 
the cover closure/funnel to add the material, 
as shown in figure 14a.
For liquids, the closure/funnel may be left in 
place and the liquids added by pouring it 
into the closure/funnel, see figure 14b.
Figure 14
Removing Contents
Before beginning to remove the contents 
from the blender, make sure that the power 
unit has been turned to the Off position, 
“0/off”. Remove the blender from the power 
unit by turning the blender clockwise while 
lifting. With the blender removed from the 
power unit, the contents of the blender may 
now be poured into a suitable container or 
bowl, as desired.