Wacom PenPartner - 2 Instruction Manual

Page  37

Double-clicking is difficult.

Be sure you are quickly tapping the tablet twice in the same place on the 
tablet’s active area.

Using a side switch to double-click is recommended (review the techniques 
in 

.

Try increasing the D

OUBLE

-C

LICK

 D

ISTANCE

 (see 

). 

Try using a lighter T

IP

 F

EEL

).

Try setting your system to launch programs with a single click 
(see 

The pen selects everything, will 
not stop drawing.

Open the Pen Tablet control panel.  Move the T

IP

 F

EEL

 slider toward F

IRM

.

You notice a delay at the 
beginning of pen strokes.

In the Pen Tablet control panel, try decreasing the D

OUBLE

-C

LICK

 D

ISTANCE

 

(see 

You have to press hard with the 
pen when clicking or drawing.

Open the Pen Tablet control panel.  Move the T

IP

 F

EEL

 slider toward S

OFT

.

The pen tip does not function.

Make sure the status LED changes from orange to green when the tip is 
pressed to the tablet surface.  If it does not, you may have defective 
hardware (see 

).

The side switch does not work.

Be sure you press the side switch when the pen tip is within 5 mm 
(0.20 inch) of the tablet’s active area – do this without pressing down on the 
pen tip.

From the Pen Tablet control panel, verify that the side switch in question is 
set to the function you are expecting to occur.

Make sure the tablet status LED changes from orange to green when you 
press the side switch.  If it does not, you may have defective hardware (see