Linksys X3500 Owner's Manual

Installation

Linksys X-Series

5.  Connect the other end of the phone cable to the wall jack with ADSL 

service or microfilter .

If you experience static on your phone line, you may need a 

microfilter or splitter . (This is required for users in the UK; other 

users should contact their ISPs to verify . ISDN users do not need 

a microfilter .) If you require a microfilter, you must install one for 

each phone or fax that you use . To install a microfilter, plug it into 

a phone jack that has ADSL service, then connect one end of the 

provided phone cable to the microfilter’s DSL port .

6.  Connect one end of the power adapter cord to the Power port and the 

other end to the electrical outlet .

7.  Power on the computer that you will use to configure the modem-router .
8.  The  LEDs  for  Power,  Wireless,  and  Ethernet  (one  for  each  connected 

computer)  should  light  up .  If  not,  make  sure  the  modem-router  is 

powered on and the cables are securely connected .

Run the Setup CD-ROM to install the modem-router . If you cannot 

run the Setup CD-ROM, refer to the steps below .

To set up your modem-router as a router: 
1.  Connect  one  end  of  the  provided  Ethernet  cable  to  your  computer’s 

Ethernet adapter and the other end to an Ethernet port on the back of 

the modem-router .

2.  Connect one end of an Ethernet cable to the Cable port on the back of 

the modem-router, then connect the other end to an available Ethernet/

LAN port on your modem .

3.  Connect one end of the power adapter cord to the Power port and the 

other end to the electrical outlet .

4.  Power on the computer that you will use to configure the modem-router .
5.  The  LEDs  for  Power,  Wireless,  and  Ethernet  (one  for  each  connected 

computer)  should  light  up .  If  not,  make  sure  the  modem-router  is 

powered on and the cables are securely connected .