BMW 2011 328i Sedan Owner's Manual
Replacing components
240
Access to the lamps
The high-beam headlamp can be accessed
from the engine compartment, whereas the
low-beam headlamp is accessed through a flap
in the wheel well.
from the engine compartment, whereas the
low-beam headlamp is accessed through a flap
in the wheel well.
1 Cover for high-beam headlamp
2 Cover for low-beam headlamp
3 Turn signal bulb socket
To remove the covers:
2 Cover for low-beam headlamp
3 Turn signal bulb socket
To remove the covers:
1.
Fold the respective wire bracket to the side,
see arrows.
see arrows.
2.
Flip open the cover and take it out of the
guide.
guide.
Follow the same steps in reverse order to reat-
tach the covers.
tach the covers.
Access through the wheel well
Only for low-beam headlamps and turn signals:
1.
Turn the wheel inwards.
2.
Open the flap in the wheel well. To do so,
turn the fastener counterclockwise using a
coin, for example.
turn the fastener counterclockwise using a
coin, for example.
Changing low-beam and high-beam
bulbs
bulbs
1.
Remove the relevant cover for the head-
lamp.
lamp.
2.
Disconnect the plug from the lamp.
3.
Push the wire bracket to the side out of the
mounting, arrow
mounting, arrow
1, and fold it down,
arrow
2.
4.
Remove the bulb.
5.
Insert new bulb as shown in the detail of the
illustration above.
illustration above.
6.
Fold up the wire bracket and engage it.
7.
Connect the plug.
8.
Reattach the cover.
Parking lamps, roadside parking lamps
W5W bulb, 5 watts
1.
Remove the cover for the high-beam head-
lamp.
lamp.
2.
Pull out the bulb socket, see arrow.
3.
Remove and replace the bulb.
4.
Insert bulb socket.
5.
Reattach the cover.
Online Edition for Part no. 01 41 2 604 582 - © 02/10 BMW AG