Summit PRO24G User Manual
DANGER: Electrical shock hazard!
•
Use extreme caution when drilling
holes into the wall or floor. There
may be concealed electrical wires
located behind the wall or under the
floor.
holes into the wall or floor. There
may be concealed electrical wires
located behind the wall or under the
floor.
•
Identify the electrical circuits that
could be affected by the installation of
the Anti-Tip Device, then turn off
power to these circuits.
could be affected by the installation of
the Anti-Tip Device, then turn off
power to these circuits.
Failure to follow these instructions
may result in electrical shock or
other personal injury.
may result in electrical shock or
other personal injury.
Connection to the Gas Supply
This appliance has been tested in
accordance with the following
standards:
accordance with the following
standards:
•
ANSI Z21.1 Standard for Household
Cooking Appliances (USA).
Cooking Appliances (USA).
•
CAN 1.1 M81 Interim Reqt no. 58
Domestic Cooktops (CANADA).
Domestic Cooktops (CANADA).
•
CAN/CSA-C 22.2 No. 61-M89
Household Cooking Ranges.
Household Cooking Ranges.
In Canada, installation must be in
accordance with CAN 1-B149.1 and 2
Installation Codes for Gas Burning
Appliances and/or local codes.
For Massachusetts Installations:
1. Installation must be performed by a
accordance with CAN 1-B149.1 and 2
Installation Codes for Gas Burning
Appliances and/or local codes.
For Massachusetts Installations:
1. Installation must be performed by a
contractor, plumber or gas fitter
qualified or licensed by the state,
province or region where this
appliance is being installed.
qualified or licensed by the state,
province or region where this
appliance is being installed.
2. Shut-off valve must be a "T" handle
gas cock.
3. Flexible gas connector must not be
longer than 36 inches.
High Altitude Installation note:
This gas range is ETL-certified for safe
operation up to an altitude of 10,000 ft.
without any modifications.
Exception: For use with LP, the range
must first be converted using the LP
conversion instructions included in
this literature package.
conversion instructions included in
this literature package.
Connecting to the gas supply:
Important note for LP users
The range is shipped from the factory
for use with natural gas. For use with
propane (LP) gas, your range must first
be converted using the LP conversion
kit.
The gas connection is located below the
back panel of the range (see figure 4).
It is accessible through the warming
drawer access panel or from the back of
the range. To reach the access panel,
remove the warming drawer.
Shut off the main gas supply valve
before disconnecting the old range and
leave it off until the new hook-up has
been completed.
The gas range can be installed using
rigid pipe or a CSA, cCSAus, UL-
International certified metal appliance
connector. If using a flexible connector,
always use a new connector.
Apply pipe joint compound or Teflon
tape appropriate for use with LP gas
and natural gas around all male pipe
threads to prevent leaks.
14