Friedrich WS10D10 Installation Instruction

Figure 2

920-122-00 (3-07)

2. From inside the building, grasp the louver at the

vertical supports and maneuver the louver through the

wall sleeve. Pull towards you until the threaded studs
are inserted into the four holes of the wall sleeve.

CAUTION: Bodily injury can be caused by louvers

falling from a building during installation. It is

recommended that a safety line be attached to

the louver and an anchor point inside the building

during installation.

3. While holding the louver with one hand, start washers

and nuts on each of the four studs. Tighten the nuts
securely.

Installation

1. Screw a threaded metal stud into each of the holes

at the four corners of the louver.

Architectural
Louver

Threaded Stud

Louver

Wall

Sleeve

Installation Instructions

ARCHITECTURAL LOUVER

For Use With Packaged Terminal Units

Please read these instructions completely before attempting installation.
NOTE: These instructions apply to the Packaged Terminal Unit Architectural Louver Installation Kit ONLY. Refer to chassis

Installation/Operation manual and Wall Sleeve Installation Instructions for additional information.

Check box for parts listed in Figure 1.

Models PXAA / PXBG / PXSC

Parts list - Architectural Louver
Description
Architectural Louver
#10-24 x 1" Threaded Metal Studs

#10-24 Hex Nuts
7/32" I.D. Flat Washers

Figure 1

Quantity

1
4

4
4