Fire Magic A430S6E1NP6 Quick Setup Guide

Page of 2
Outdoor Stand Alone
Gas Grill
Quick Start Guide
INSTALLER:  Leave these instructions with consumer.     CONSUMER: Retain for future reference.
CAUTION: For your safety read the installation instructions and owner’s manual provided with the grill.
This grill must be installed in accordance with local codes and ordinances, or, in the absence of local codes, with either the latest National Fuel Gas Code (ANSI  
Z223.1/NFPA 54), and Natural Gas and Propane Storage and Handling Installation Code (CSA-B149.1).
This appliance and its individual shutoff valves must be disconnected from the gas-supply piping system when testing the system at pressures in excess of ½ psig. 
This appliance must be isolated from the gas-supply piping system by closing its dedicated manual shutoff valve during any pressure testing of the gas-supply 
system at pressures up to and including ½ psig.
This grill is designed for outdoor use only. DO NOT use this grill under unprotected fl ammable surfaces. DO NOT use this grill inside a building, garage, 
enclosed area, or an unprotected covered area (see paragraph below). DO NOT use this grill in or on a recreational vehicle or boat.
If installed or used under a patio roof, the cooking grid area must be covered by an exhaust hood (with a vent) larger than the cooking surface. Refer to manufacturer 
specifi cations. An exhaust fan with a rating of 1,000 CFM (cubic feet per minute) (472 liters per second) or more may be necessary to effectively remove smoke and other 
cooking by-products from the area under the hood. Fire Magic Vent Hoods are available to meet this requirement. This grill must not be used under unprotected 
overhead combustible construction. THIS UNIT MUST NOT BE LOCATED IN A FULLY ENCLOSED AREA OF ANY KIND.
2-Unpacking
Carefully unpack the grill, removing all packing material and protective fi lm. Verify that all 
parts have arrived undamaged by consulting the parts list in the owner’s manual. Remove 
foam packed hardware from oven area. (See Fig. 2-1.) 
Consult the parts list in the owner’s manual. If any parts are missing or damaged, 
immediately contact the Fire Magic dealer before beginning installation.
Fig. 2-1
1-Safety
Lift out foam packed hardware
Remove plastic 
zip-ties
3-Installation
Location
Locate the grill on a flat level surface. Refer to the INSTALLATION 
REQUIREMENTS section of your grill owner’s manual for complete details.
CAUTION:  Wind blowing into or across the rear oven lid vent (Fig. 
3-1) can cause poor performance and/or dangerous 
overheating. Orient the grill so that the prevailing wind 
blows toward the front of the grill (Fig. 3-2).
CAUTION:  To prevent dangerous overheating, the rear of the unit must have 
a minimum clearance of 4” (10.2 cm) from any backsplash/wall.
Fig. 3-2
CORRECT
PLACE GRILL SO PREVAILING WIND 
BLOWS TOWARD FRONT OF GRILL
YOU MUST PROTECT REAR OVEN 
VENT FROM PREVAILING WIND
Rear oven lid vent
INCORRECT
Fig. 3-1
Re
Rear
ar o
 ove
ven 
n lilid 
d ve
vent
nt
Ventilation diagram
Fig. 3-5
To connect the regulator/
h o s e   a s s e m bly   t o   t h e 
propane-gas cylinder valve 
fi tting:
 Press the hand nut 
on the regulator over the 
Acme thread fi tting on the 
cylinder valve. Turn the hand 
nut clockwise to engage the 
threads and tighten until 
snug. 
UL
Fig. 3-4 Type I Acme thread quick coupler
Vent
QCC 
Type 1 
valve
Brass Acme 
thread fi tting
Liquid level 
indicator 
(optional)
Hand nut with 
Acme thread
Regulator
Hose
Hand wheel
Pressure 
relief 
valve
Connect Gas supply
These quick start instructions assume a 
propane cylinder confi gured unit. See main 
instructions for natural gas or household 
propane confi gured units.
Place approved propane 20lb cylinder in tank 
tray and lock holder in position (Fig. 3-3).
Connect quick coupler hose and regulator 
supplied with unit to propane cylinder (Fig. 
3-4).
Set all burner control valves to OFF and 
open gas source control valve. 
Follow the lighting instructions on the 
reverse side of this guide.
Proper grill airfl ow must be maintained as 
shown in Fig. 3-5.
Fig. 3-3
Quick 
coupler
Propane 
cylinder (tank)
Sideburner 
shelf (if 
equipped)
Tool holder 
Paper towel 
holder
Backburner 
cover (if 
equipped)
Tank tray latch
Installation must be performed by a qualifi ed professional service technician.
REV 0 - 1409250910
L-C2-446