Danby DIM3225BLSST Manual

2

• Remove the exterior and interior packaging.

• Before connecting the Ice Maker to the power source, let

it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling
system from handling during transportation.

• Clean the interior surface with lukewarm water using a

soft cloth.

• Attach the water inlet and outlet pipe, loosen the screw

nut, choose the function switch. (see Ice Maker
performance mode instructions)

• Before use, please make two full boxes of ice and then

dispose it to insure the ice is clean and healthy.

• When disposing your appliance, please choose an

authorized disposal site.

• Place your Ice Maker on a floor that is strong  enough to

support it when it is fully loaded. To level your Ice Maker,
adjust the front leveling leg at the bottom of the unit.

• Locate the Ice Maker away from direct sunlight and

sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating on the exterior of
the unit and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly.`

• Avoid locating the unit in moist areas. 

• Plug the unit into an exclusive, properly installed-

grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an
authorized Products service center.

• Do not open the door unless necessary.

• Should the Ice Maker be stored without use for long

periods it is suggested, after a careful cleaning, to leave
the door ajar to allow air to circulate inside the cabinet
in order to avoid possible formations of condensation,
mold or odors.