Hotpoint HTDP120GDWW Specification Sheet

470163

3-way via rear, left and bottom. Dryer is shipped exhausted to the rear. Alternate exhausting 

knockouts are supplied. 
Circuit Requirements: 

An individual properly-grounded branch circuit, with a three-prong grounding-type receptacle, 

protected by a 15- or 20-amp circuit breaker or a time-delay fuse is required.
Gas Dryer Electric Rating:  

120V, 60Hz, 6 Amp
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas. LP gas supply 

requires an optional conversion kit. Check installation instructions for  correct kit and have a 

qualified gas technician install a conversion kit. See dryer ducting information for proper 

installation.
Installation Information: For complete information, see installation  

instructions packed with product for current dimensional data.

•  If your dryer is approved for installation in an alcove or closet, it will be stated on a 

label on the dryer back.

• The dryer MUST be exhausted to the outside.

•  Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 

       0" either side 

       3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52". 

•  Closet doors must be louvered or otherwise ventilated and must contain a minimum of 

60 sq. in. of open area equally distributed. If this closet contains both a washer and a 

dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors. 

•  The installation must conform with the local codes, or in the absence of local codes, 

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

•  Minimum clearances to combustible surfaces 

       0" both sides 

       3" rear

36

24

42-3/4

51

Side View

24

Rear View

36

42

27

2

5-1/2

2-1/2

25-1/2*

Side View

Rear View

4-3/4

25-3/4

23-1/2

11-3/4

HTPWasher/Dryess LC QSart

* 24-1/2” from the edge of the side panel to the front.  

25-1/2” from front to edge of end caps.