Bosch HCB50651UC Installation Instruction

11

Use 4 screws (4x8 mm) to screw the housing for the 

recirculation module to the angle bracket.

Measure the distance (x) between the lower edge of 

the housing for the recirculation module and the lower 

edge of the back-pressure flap.

Shorten the exhaust air pipe to the length measured.

Remove the recirculation module.

Push the exhaust air pipe onto the bottom of the 

recirculation module.

Position the recirculation module with exhaust air pipe 

over the air extraction duct of the extractor hood.

Use 4 screws to fasten the recirculation module to the 

angle bracket.

Secure connections with clamps.

9

RISK OF ELECTRIC SHOCK
Before wiring the appliance, interrupt the main 

electrical circuit at the electrical control cabinet. A 

circuit with 120 VAC, 15 or 20 Ampere is required.
Grounding notes: this appliance is equipped with a 

distributor box with 3 cables. Use the green-yellow 

cable for grounding the appliance. Connect the 

green-yellow cable to the grounding cable on the 

house connection to prevent electric sthock. Do not 

under any circumstances damage or remove the 

green-yellow cable. Non-adherence can cause 

deadly injuries or electric shock.

Remove the left cable passage and the cover of the 

motor controller. Fasten the connecting piece for the 

installation pipe (listed in cULUS) to the cable 

passage.

Connect 1/2" (12.7 mm) installation pipe to motor 

controller.

A

Screws

B

Recirculation module

C

Angle bracket

A

Recirculation module

B

Clamps

C

Flue duct

D

Exhaust air duct

$

%

&

$

[

%

&

'

A

Cable passage

B

Cover of the motor controller

A

Installation pipe

B

Power connection

C

Cable connector listed in UL

$

%

$

%

&