Whirlpool CEM2793BQ Installation Instruction

Coin-slide models: You can install the 30-minute or 60-minute 

timing cam (shipped with dryer) as follows:
1.  Unplug dryer or disconnect power.
2. Unlock meter case.
3.  Turn the timing cam by hand until the V-shaped notch lines 

up below the ratchet tooth.

4.  Insert a narrow, flat-blade screwdriver under the timing cam 

near the clock shaft. Gently lift cam straight up and off shaft, 

making sure that the V-shaped notch clears the ratchet tooth.

5.  Place new cam (hub side down) over clock shaft. Line up flat 

side of shaft with flat side of cam hole. Check that drive lug 

is in place.

6.  Turn cam until V-shaped notch lines up with ratchet tooth.

7.  Press cam down in place on clock shaft. Make sure that 

V-shaped notch clears the ratchet tooth.

8. Close and lock the meter case.
9. Plug in dryer or reconnect power.