Amana NED5800DW Quick Setup Guide

Connect neutral ground wire (E) and neutral wire (white or 

center wire) (C) of power supply cord or cable under center, 

terminal block screw (B). Tighten screw.

Place ends of remaining wires under outer terminal block 

screws. Tighten screws. 

Connect a separate copper ground wire (G) under the green 

external ground conductor screw (A) to an adequate ground. 

Finally, reinsert tab of terminal block cover into slot of dryer 

rear panel. Secure cover with hold-down screw. Now, go to 

“Venting Requirements.” 

IMPORTANT: You must verify with a qualified electrician that this 

grounding method is acceptable before connecting.

C

E

B

E

B

A

G

A

Install the correct strain relief for your electrical connection 

method, as shown on page 8 or 10. 

Remove center terminal block screw (B). Remove neutral ground 

wire (E) from green external ground conductor screw (A).

To reduce the risk of fire, this dryer MUST BE 

EXHAUSTED OUTDOORS.
IMPORTANT: Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent, 

chimney, wall, ceiling, attic, crawlspace, or a concealed space 

of a building. Only rigid or flexible metal vent shall be used for 

exhausting.

4" (102 mm) heavy metal exhaust vent

 

■

Only a 4" (102 mm) heavy metal exhaust vent and clamps  

may be used. 

 

■

Do not use plastic or metal foil vent.