Amana NED5800DW Quick Setup Guide

Gather the required tools and parts before starting installation.

Flat-blade screwdriver

#2 Phillips screwdriver

Adjustable wrench that 

opens to 1" (25 mm)  or 

hex-head socket wrench 

Wire stripper (direct wire 

installations)

Tin snips (new vent 

installations)

1/4" and 5/16" nut driver 

(recommended)

Utility knife 

 Level

Tape measure

Pliers

Caulking gun and 

compound (for installing 

new exhaust vent)

Leveling legs (4)

“Y” connector

Parts package is located in dryer drum. Check that all parts  

are included.
NOTE: Do not use leveling legs supplied with dryer if installing 

with a pedestal or a stack kit.

Additional parts may be required, depending in your installation. 

Check local codes. Check existing electrical supply and venting. 

Read “Electrical Requirements” and “Venting Requirements” 

before purchasing parts. 

Use a UL listed power supply cord kit marked for use with  

clothes dryers. The kit should contain:

 

■

A UL listed 30-amp power supply cord, rated 120/240 volt 

minimum. The cord should be type SRD or SRDT and be  

at least 4 ft. (1.22 m) long. The wires that connect to  

the dryer must end in ring terminals or spade terminals  

with upturned ends.

 

■

A UL listed strain relief.

(Not supplied with dryer) 

Refer to your Use and Care Guide for information about 

accessories available for your dryer.

2' (0.6 m) inlet hose

5' (1.52 m) inlet hose 

and rubber washer

(Not supplied with dryer)

 

■

Vent clamps

 

■

Vent elbows and vent work