Fire Magic 60VH6 Installation Instruction

REV 2 - 1406051400

L-C2-387

18

This vent hood will require electrical work, and includes a 
power cord. The install will need a dedicated GFI receptacle 
installed near the vent hood to allow for the power cord to 
be plugged into. The area above the vent hood that the 
soffi t / duct cover will enclose is an ideal location (reference 
Fig. 18-1).

1.  Install GFI receptacle accordingly.

Observe all codes.

2.  Plug the power cord into the GFI receptacle.

Note:  The power cord must be plugged in when operating 

the vent hood.

Note:  Some installs may not require a duct cover / soffi t, 

as island height & roof height may vary.

Fire Magic offers a duct cover specifi cally designed for your 
vent hood. Contact your dealer for ordering information. 
Alternatively, a custom soffi t can be constructed for your 
setup. Follow the appropriate section for your spacer type.

The Fire Magic duct cover comes ready to be installed.

1.  Carefully slide the duct cover into the area above the 

already installed spacer and vent hood. Ensure the 
bottom perimeter of the duct cover rests fl ush with the 
spacer and vent hood. See Fig. 18-2.

2.  From beneath the vent hood, use a medium Phillips 

screwdriver and the 8-32 x 3/8" screws 

 

supplied with 

the duct cover to secure it to the vent hood. (The screws 
are to be fastened through the pilot holes found on top 
of the vent hood and into the duct cover above.) See 
Fig. 18-2.

Important:  To prevent cross-threading the screws they 

should be installed with a manual screwdriver 
and a small amount of household grease.

Note:  The rear of the duct cover does not need to be 

secured to the rear wall.

Important:  DO NOT apply sealant to the duct cover as 

it must be removable for servicing and for 
access to the electrical connection. 

Fig. 18-1 Install GFI receptacle, connect power cord

Fig. 18-2 Install Fire Magic Duct Cover

(Flush)