Bosch B36BT830NS Use & Care Manual

Have a technician install and connect the appliance 

according to the enclosed Installation Instructions.
Do not remove the transportation protection devices 

from the shelves and storage compartments until 

the appliance has been installed.
Always connect the water before the power.
Apart from statutory national regulations, you should 

comply with all applicable local electricity and water 

companies codes and requirements.
After installing the appliance, wait at least 1 hour before 

switching the appliance On. During transportation 

the oil in the compressor may have flowed into 

the refrigeration system.
Before switching the appliance On for the first time, 

clean the interior of the appliance (see chapter 

“Cleaning the Appliance”).

,

CAUTION: 
Connect the appliance to a drinking water line 

only:

■

Minimum pressure: 0.2 Mpa (2 bar)

■

Maximum pressure: 0.8 Mpa (8 bar)

■

Pressure over 0.8 MPa (8 bar): install 

a pressure limiter between drinking water 

connection and hose set:

The water may be connected only by a competent fitter 

according to the local regulations of the appropriate 

Water Supply company.
A cold water connection is necessary for operating 

the automatic Ice Maker. The water pressure must be 

between 29 and 116 p.s.i. (2.0 and 8.0 bar). The 

installation must correspond to the local plumbing 

regulations.
A separate Shut-Off-Valve should be installed in 

the cold-water inflow.
The Shut-Off-Valve should not be located behind 

the appliance. It is recommended that you mount 

the Shut-Off-Valve directly next to the appliance or at 

another place that is easily accessible.
When installing the water connection, pay attention to 

the permissible installation area for the water line.
For connection to the drinking water line use only water 

pipes that are suitable for drinking water. Observe 

national regulations and the connection conditions of 

the local Water Supply companies.

,

WARNING: 
Avoid the risk of an electric shock!

,

WARNING: 
Insert into a grounded 3-phase receptacle. Never 

remove grounding phase. Do not use any 

adapters. Do not use any extension cords.

,

WARNING: 
Non-compliance with these instructions may 

result in death, fire or an electric shock. 

Improper connection of the protective conductor 

may result in an electric shock. If you are in 

doubt whether the appliance has been grounded 

properly, have the appliance tested by 

a qualified electrician or service technician.

Do not use extensions or distributors.
The receptacle must be installed according to the 

Installation Manual.
The appliance complies with protection class I. 

Connect the appliance to 115 V/60 Hz AC through 

a correctly installed 3-pole grounded receptacle. 

The receptacle must be protected with a 10 to 16 A 

fuse.
The appliance comes with a UL registered 3-wire 

Power Cord.
Please see the following table:

Check on the Rating Plate whether the indicated 

voltage and current type correspond with the values of 

your power supply. The location of the Rating Plate 

can be found in the chapter “Customer Service”.

,

WARNING: 
Never connect the appliance to electronic 

energy saving devices.
Our appliances can be used with power line and 

sine-controlled inverters. Power line-controlled 

inverters are used for photovoltaic systems 

which are connected directly to the national grid. 

Sine-controlled inverters must be used for 

isolated applications (e.g. on ships or 

in mountain lodges) which are not connected 

directly to the national grid.

Fridge-

freezer

6.0 amps