Intel AUGSBURG S775 I915G MATX 10PK KD915GAGLKPAK10 User Manual

Product codes

KD915GAGLKPAK10

Intel Desktop Board D915GAV/D915GAG Technical Product Specification

1.6 System Memory

The boards have four DIMM sockets and support the following memory features:
• 2.5 V (only) DDR SDRAM DIMMs with gold-plated contacts

• Unbuffered, single-sided or double-sided DIMMs with the following restriction:

Double-sided DIMMS with x16 organization are not supported.

• 4 GB maximum total system memory. Refer to Section 2.2.1 on page 53 for information on the

total amount of addressable memory.

• Minimum total system memory: 128 MB

• Non-ECC DIMMs

• Serial Presence Detect
• DDR 400 MHz and DDR 333 MHz SDRAM DIMMs

Table 6 lists the supported system bus frequency and memory speed combinations.

Table 6.

Supported System Bus Frequency and Memory Speed Combinations

To use this type of DIMM…

The processor's system bus frequency must be…

DDR 400

800 MHz

DDR 333 (Note)

800 or 533 MHz

Note:

When using an 800 MHz system bus frequency processor, DDR 333 memory is clocked at 320 MHz. This minimizes
system latencies to optimize system throughput.

✏

NOTES

• Remove the PCI Express x16 video card before installing or upgrading memory to avoid

interference with the memory retention mechanism.

• To be fully compliant with all applicable DDR SDRAM memory specifications, the board

should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure.
This allows the BIOS to read the SPD data and program the chipset to accurately configure
memory settings for optimum performance. If non-SPD memory is installed, the BIOS will
attempt to correctly configure the memory settings, but performance and reliability may be
impacted or the DIMMs may not function under the determined frequency.