Whirlpool WFE515S0ES Installation Instruction

6. Repeat steps 1 and 2 to ensure that the range foot is 

engaged in the anti-tip bracket.

If the rear of the range lifts more than ½" (1.3 cm) off the floor 
without resistance, the anti-tip bracket may not be installed 
correctly. Do not operate the range without anti-tip bracket 
installed and engaged. Please reference the “Assistance or 
Service” section of the Use and Care Guide, or the cover or 
“Warranty” section of the User Instructions, to contact 
service.

Determine if you have AquaLift

®

 Technology or Steam Clean by 

referring to the “Range Care” section of the User Instructions.

®

1. Place level on the oven bottom as indicated in one of the two 

figures below depending on the size of the level. Check with 
the level: side to side and front to back.

2. If range is not level, pull range forward until rear leveling leg is 

removed from the anti-tip bracket.

3. Follow the directions in Style 1 or Style 2, depending on the 

style of drawer supplied with the range.

®

1. Place a standard flat rack in oven. 

2. Place level on the rack and check levelness of the range, first 

side to side; then front to back.

3. If range is not level, pull range forward until rear leveling leg is 

removed from the anti-tip bracket.

4. Follow the directions in Style 1 or Style 2, depending on the 

style of drawer supplied with the range.

Use

 a ¼" drive ratchet, wrench or pliers to adjust leveling legs 

up or down until the range is level. Push range back into 
position. Check that rear leveling leg is engaged in the anti-tip 
bracket.

Use a wrench or pliers to adjust leveling legs up or down until 
the range is level. Push range back into position. Check that 
rear leveling leg is engaged in the anti-tip bracket.

NOTE: Range must be level for satisfactory baking 
performance and best cleaning results using AquaLift

®

 

Technology and Steam Clean functions.

Remove all items from inside the warming drawer or premium 
storage drawer, and allow the range to cool completely before 
attempting to remove the drawer.

1. Open the warming drawer or premium storage drawer to its 

fully open position.

2. Using a flat-blade screwdriver, gently loosen the warming 

drawer or premium storage drawer from the glide alignment 
notch and lift up the drawer alignment tab from the glide.

3. Repeat Step 2 on the other side. The warming drawer or 

premium storage drawer is no longer attached to the drawer 
glides. Using both hands, pick up the warming drawer or 
premium storage drawer to complete the removal.

1. Align the forward drawer notches with the notches in the 

drawer glides on both sides. Place the rear alignment tabs 
into the drawer glides on both sides.

2. Push the warming drawer or premium storage drawer in all 

the way.

3. Gently open and close the warming drawer or premium 

storage drawer to ensure it is seated properly on the glides 
on both sides.

A

B

C

A

B