APC Condenser 2 EC Fan ACCD75208 User Manual

Product codes
ACCD75208
Page of 50
InRow RP Technical Data Manual
8
Alarms
The microprocessor controller shall 
activate a visible and audible alarm 
in the following occurrences:
•  Cool Fail
•  Rack inlet temperature violation
•  Rack inlet temperature sensor fault
•  Air filter clogged
•  Air filter run hours exceeded
•  Filter DP sensor failure
•  Supply air sensor fault
•  Return air sensor fault
•  Supply air high temperature 
violation
•  Return air high temperature 
violation
•  Fan fault
•  Fan run hours exceeded
•  Water detection fault
•  Condensate pump fault
•  Condensate run hours exceeded
•  Humidifier water conductivity high 
violation
•  Humidifier fault tolerance exceeded
•  Humidifier low water
•  Humidifier excessive output 
reduction
•  Humidifier drain fault
•  Humidifier cylinder full
•  Humidifier replace cylinder
•  Humidifier RS485 communication 
fault
•  Humidifier run hours violation
•  Humidity high/low violation
•  Supply humidity sensor fault
•  Return humidity sensor fault
•  Heater fault
•  Heater run hours exceeded
•  Heater interlock shutdown
•  Group communication fault
•  Internal communication fault
•  A-link isolation relay fault
•  External communication fault
•  Input contact fault
•  Invalid supply setpoint
•  Idle mode active
Chilled Water Only Alarms
•  Coil fluid valve actuator fault
•  Fluid flow fault
•  Entering fluid temperature high 
violation
•  Entering fluid temperature sensor 
fault
•  Leaving fluid temperature sensor 
fault
•  Power source failure
•  Fluid calibration
Air-cooled Only Alarms
•  High discharge pressure
•  Low suction pressure
•  High suction pressure
•  Compressor drive failure
•  Compressor drive warning
•  Compressor run hours violation
•  Compressor drive RS485 
communication fault
•  Excessive compressor cycling
•  Air flow decreased while 
compressor off
•  Suction pressure sensor failure
•  Discharge pressure sensor failure
•  High pressure switch active
•  Fan speed decreased to avoid high 
pressure (event only)
•  Compressor speed decreased to 
avoid high pressure (event only)
•  Compressor high pressure
•  Oil return pump active