Bosch NET8666SUC Installation Instruction

Page of 24
4
Before You Begin
Tools and Parts Needed
Phillips Head Screwdriver
Pencil
Drill with ¼" (6 mm) bit
Jigsaw
Tape Measure
Note:  Additional materials may be necessary for 
installation in solid surface countertops. Contact the 
countertop manufacturer.
Parts Included
Cabinet Requirements
The distance from the top of the cooktop to the bottom of 
cabinets above must be a minimung of A=30" (762 mm) 
min. This distance can be reduced to A=24" (610 mm) 
when the bottom of the wood or metal cabinet is 
protected by not less than ¼" (6.35 mm) flame-retardant 
millboard covered with not less than no. 28 gauge sheet 
metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) 
aluminum or 0.020" (0.5 mm) copper.
Verify that the cabinets above the cooktop are a 
maximum of B=13" (330 mm) deep.
Countertop Requirements
9
WARNING
To reduce the risk of ignition of surrounding 
combustible materials, install at least 2" (51 mm) 
from both sidewalls and the rear wall.
The countertop must be level and horizontal. The stability 
of the countertop must be maintained after the cut-out 
has been made.
Solid surface countertops often require special 
installations. For example, heat-reflective tape and 
rounded corners may be necessary. Contact the 
countertop manufacturer for instructions specific to your 
countertop.
%
$