Bosch HMV3022U Installation Instruction

14

Insert the two remaining self-aligning screws through 

outer top cabinet holes. Turn two full turns on each 

screw.

Tighten center screw completely.

Tighten the outer two screws completely to the top of 

the microwave oven.
Note:  While tightening screws, hold the microwave 

oven in place against the wall and the top cabinet.

Install grease filters by sliding them into the side slots, 

then pushing up and toward oven to lock (image 

shows bottom view of appliance).

When venting exhaust to the outside, hood exhaust 

ducts will be required. Read the following carefully.
Note:  It is important that venting be installed using the 

most direct route and with as few elbows as possible. 

This ensures clear venting of exhaust and helps prevent 

blockages. Also, make sure dampers swing freely and 

nothing is blocking the ducts.
The hood exhaust has been designed to mate with a 

standard 3¼" x 10" (82 x 254 mm) rectangular duct. If a 

round duct is required, a rectangular-to-round transition 

adaptor must be used. Do not use less than a 6" 

(152 mm) diameter duct.
For satisfactory air movement, the total duct length of 

Rectangular-to-Round Tran-

sition Adaptor*

5 ft (1.5 m)

x

=

Wall Cap

40 ft (12.2 m)

x

=

90° Elbow

10 ft (3 m)

x

=

Total Ductwork =