Bosch HBL5451UC Instruction Manual

English 1

The following content updates the built-in oven Installation Instructions and the Use & Care Manual. Please note 
the referenced sections and refer to the content below for updated information.

•

Cut straps on the outside of the box.

•

Remove the cardboard box by lifting it up and off the 
unit.

•

Remove all top and side cardboard and Styrofoam 
braces.

•

Place the oven (leaving it on the shipping base) in front 
of the cabinet where it is to be installed.

•

Remove all accessories, racks, packing materials and 
literature from the oven cavity (for double ovens, 
remove such items, if present, from both cavities).

•

Unscrew unit from packaging brackets as shown below 
in “Packaging Bracket Removal.”
Note: The screws near the base mounting bracket are 
all torx head (T-20 size). Only the one screw that goes 
through the slotted hole in the mounting bracket on the 
left and right sides of the unit needs to be removed in 
order to lift the unit from the mounting base (the screw 
circled and shown as “A” in the illustration below.)

Note:
Different models use different packaging materials.  Actual 
brackets may look differently. The bracket remains in the 
packaging base. The unit should stay on the packaging 
base until ready to be lifted into cabinet cutout.

Omit Step 5 in the “Placing the Oven Into the Cabinet 
Opening” section referencing installation of the oven 
bottom trim. The bottom trim is already installed.

Remove one screw only from each bracket. This 
will release your oven from the shipping base. Do 
not remove any additional screws from the oven.

Oven Mounting Screws
8 screws are included to 
secure the oven trim to the 
cabinet. The screws are 
located in a small plastic 
bag affixed to the literature 
pack bag.

The bottom trim pictured below is pre-installed at the 
factory. The part is not included as a separate piece as 
noted in the installation manual. 

Oven Bottom trim (installed at factory)