Bosch HBLP751UC Installation Instruction

Page of 56
English 8
Electrical Connection to Main Power Supply
The four-wire connection is preferred, but where local 
codes permit, the three wire connection is also acceptable.
Four-wire Connection
Ungrounded Neutral
Connect the red oven wire to the red electrical supply 
wire (hot wire).
Connect the black oven wire to the black electrical 
supply wire (hot wire).
Connect the white neutral oven wire to the white 
neutral (not bare or green ground) electrical supply 
wire.
Connect the green ground oven wire to the bare or 
green ground electrical supply wire.
Three-wire Connection
Grounded Neutral
Connect red wire from oven to red wire in junction box.
Connect black wire from oven to black wire in junction 
box.
Connect both green ground wire and white wire from 
oven to white, green or bare neutral wire in junction 
box.
The conduit cable, where connected at the oven, swivels. 
Rotate conduit cable upward (or downward) and direct 
through hole prepared in cabinet to attach to J-Box.
To maintain serviceability, the flex conduit must not be 
shortened and should be routed to permit temporary 
removal of the oven.
Installing the Oven Unit into 
the Wall Cabinet
Note: 
Before installing the oven, be sure to verify the cabinet 
dimensions and electrical connections.Check that the 
cavity is level and plumb for correct installation.
Combination units (ovens with a microwave or steam oven) 
have additional installation instructions. Please see the 
preceeding section “Pre-Assembly of Combination Ovens 
Prior to Installation”.
For Best Installation
The double and combination ovens can be difficult for two 
people to handle during installation. It is recommended to 
have three or more people available to assist with lifting the 
unit into place. It is also recommended to remove the oven 
door (bottom hinge models only) to help reduce the unit 
weight and provide easier access to the handholds inside 
the oven cavity.
Removing the Bottom Hinge Oven Door
Important: Do not attempt to remove the side hinge 
door (some models).
For ease of installation, some oven doors may be removed 
to reduce the weight of the oven by 30 lbs (14 kg) per door, 
before installing into the cabinet. See instructions below.
power supply
junction box
red wires
green or bare
wire
green wire
UL listed
connector
black wires
white wires
cable from 
oven
power supply
junction box
red wires
white, bare, or
green wire
white wire
green wire
black wires
UL listed 
connector 
cable from 
oven
9
WARNING
Make sure oven is cool and power to the oven 
has been turned off before removing the door. 
Failure to do so could result in burns.
The oven door is heavy and fragile. Use both 
hands to remove the oven door. The door front 
is glass. Handle carefully to avoid breaking.
Grasp only the sides of the oven door. Do not 
grasp the handle as it may swing in your hand 
and cause damage or injury.
Failure to grasp the oven door firmly and 
properly could result in personal injury or 
product damage.
To avoid injury from hinge bracket snapping 
closed, be sure that both levers are securely in 
place before removing the door. Also, do not 
force door open or closed - the hinge could be 
damaged and injury could result.
Do not lay removed door on sharp or pointed 
objects as this could break the glass.  Lay on a 
flat, smooth surface, positioned so that the 
door cannot fall over.