Bosch HBLP751UC Installation Instruction

Page of 56
English 2
Preparation
Before You Begin
Tools and Parts Needed
Phillips head screwdriver
Star head screwdriver (T20)
Measuring tape
Drill with bit (1/8")
Parts Included
Phillips head screws (6)
General Information
Power Requirements
The outlet must be properly grounded in accordance with 
all applicable codes.
For Best Installation
The oven can be difficult for two people to handle during 
installation. It is recommended to have three or more 
people available to assist with lifting the unit into place.
Removal of the bottom hinge oven door during installation 
(to provide the necessary handholds and to significantly 
reduce the unit weight) can be cumbersome unless the 
detailed door removal instructions are followed carefully.
Note: Do not attempt to remove the side hinge door (some 
models).
Please take time to read and follow the instructions 
provided for an improved installation experience.
Checklist
Use this checklist to verify that you have completed each 
step of the installation process. This can help you avoid 
common mistakes.
___ 1. Before installing the oven, be sure to verify the 
cabinet dimensions are correct for your unit and 
the required electrical connections are present.
___ 2. Refer to the installation manual for content 
regarding Safety, Cabinet Dimensions, Removing 
Packaging, Electrical Installation, Testing the 
Installation and Customer Service.
___ 3. Remove the oven door(s) to reduce the unit weight 
and to provide access to handholds for lifting.
___ 4. Move the oven unit into place in front of the cabinet 
opening, leaving the bottom packaging on the unit 
to avoid damaging flooring.
___ 5 Remove the T20 screws holding the unit to the 
base of the carton (using Star-head screwdriver).
___ 6. If installing a combination unit (oven and 
microwave or oven and steam oven) complete the 
assembly before installing the unit.
___ 7. Team lift the unit directly into the cabinet cutout 
taking care not to pinch fingers or scratch hands or 
arms. Make sure the electrical conduit reaches to 
the connection point properly.
___ 8. Slide the unit all the way into place, making sure to 
route the electrical conduit correctly.
___ 8. Fasten the oven unit to the cabinetry opening with 
the screws supplied (using Philips screwdriver).
___ 10. Reinstall the oven door(s) removed in step 2 
above.
___ 11. Consult the complete installation instructions and 
follow the remainder of the procedures listed, 
including performing an operation test.
___ 12. All product literature and accessories (may be 
wrapped or boxed) with the oven.
___ 13. INSTALLER - Leave the literature pack and the 
accessories with the customer.