Electrolux EIED200QSW Owner's Manual

13

Care and Cleaning

•  Before cleaning the dryer interior, unplug the electrical 

power cord to avoid electrical shock hazards. 

•  Do not use any type spray cleanser when cleaning the dryer 

interior. Hazardous fumes or electrical shock could occur.

•  Clean the lint filter after every load. Lint build-up on the fil-

ter restricts air flow, which causes longer drying times. The 
filter is located at the bottom of the door opening. Remove 
by pulling straight up. Remove the lint and replace the filter. 

•  Occasionally a waxy build-up may form on the lint filter 

and/or moisture sensing bars from using dryer-added fabric 
softener sheets. To remove this build-up, wash them with 
warm, soapy water. Dry the filter thoroughly and replace. 
Do not operate the dryer without the lint filter in place. 

•  If the dryer drum becomes stained from noncolorfast 

fabrics, clean the drum with a damp cloth and a mild liquid 
household cleanser. Remove cleanser residue before dry-
ing the next load.

•  See next page for more information regarding cleaning of the 

condenser assembly.

•  Clean the cabinet with mild soap and water. Never use 

harsh, gritty or abrasive cleansers.

•  Remove debris and lint from the front of the condenser 

door with a vacuum cleaner.

•  Remove glue residue from tape or labels with a mixture of 

warm water and mild detergent. Or, touch residue with the 
sticky side of the tape or label.

•  Before moving the dryer, place a strip of cardboard or thin 

fiberboard under the front leveling legs to prevent damage 
to the floor.

Do not store or place laundry products on top of dryer at any 
time. They can damage the finish or controls.

Clean the lint filter and dump water container after every 
load.

To reduce risk of fire or serious injury to persons or property, 
comply with the basic warnings listed in the Important Safety 
Instructions and those listed below.