Whirlpool CEM2793BQ Specification Sheet

Page of 2
TORX is a registered Trademark of Textron Industries, Inc.
®/™ © 2013 Whirlpool. All rights reserved. 
Whirlpool Corporation • Benton Harbor, Michigan 49022 U.S.A.  
WY13010   4/13
To Locate a Distributor Near You, Please Visit www.whirlpoolcommerciallaundry.com/distributor, or call 1-800-662-3587.
Featuring Mechanical Controls
Whirlpool® Non-Metered Commercial Dryers
Mechanical Controls
DRYER SPECIFICATIONS
MODELS
CEM2793BQ
CGM2793BQ
GENERAL INFORMATION
Modern design and look with metal console and 
ergonomic control knobs. 
DRUM VOLUME
7.4 Cu. Ft.
7.4 Cu. Ft.
MOTOR
1/3 HP Single-Speed Motor with Built-In 
Overload Protector
1/3 HP Single-Speed Motor with Built-In 
Overload Protector
ELECTRICAL REQUIREMENTS
3-Wire Nominal 240/208 Volt, 60 Hz, A.C.  
Standard, 30-Amp Breaker/Fuse Circuit per Dryer 
(Subject to Local Codes) 
120 Volt, 60 Hz, A.C. Standard,  
15-Amp Breaker/Fuse Circuit per Dryer  
(Subject to Local Codes) 
HEATER TYPE
Electric
Gas*
HEATER/BURNER RATING
Heater Rated at 5600 Watts
22,000 BTU Natural Gas
OPERATIONAL AMPERAGE
Motor—4.0 AMPS, No Load 
Heater—23.33 AMPS @ 240 Volt—27.33 Total
Motor—4.0 AMPS, No Load
SHIPPING WEIGHT (EST.)
152 lb. crated, 138 lb. uncrated
152 lb. crated, 138 lb. uncrated
DIMENSIONS
Cabinet Width—in. (mm)
27 (686)
27 (686)
Cabinet Depth—in. (mm)
29.25 (743)
29.25 (743)
Cabinet Height—in. (mm) at Top of Metercase
40.8 (1036)
40.8 (1036)
*Burner orifices are available for manufactured, natural, mixed and LP gas with varying BTU ratings. 
Dimensions are for planning purposes only. For complete information, 
see installation instructions packed with product.
®Registered trademark/™Trademark of Whirlpool, U.S.A. ©2009 Whirlpool Corporation. All rights reserved.
Whirlpool Corporation • Benton Harbor, Michigan 49022 U.S.A.
WL100014   1/10
COMMERCIAL WASHER SPECIFICATIONS
Whirlpool® Commercial Washer 
ENERGY STAR® RATED
HIGH-EFFICIENCY
FRONT-LOAD WASHER
WASHER SPECIFICATIONS
MODEL
CHW9900WQ
MOTOR
Variable-speed, reversible, thermoprotected, 
high-efficiency controlled induction
Wash – HP (kWh)
.09 (.07)
Extract – HP (kWh)
.54 (.40)
Average kilowatt hour per cycle
0.07
APPROXIMATE WATER USAGE – gallons (liters)
Average hot water usage, hot cycle
3.32 (12.6)**
Average hot water usage, warm cycle
1.87 (7.08)**
Average total water usage per cycle
13.3 (50.3)**
ELECTRICAL RATING
Domestic model – voltage
120V/60Hz
BREAKER/FUSE REQUIREMENTS
Domestic amps
15
CYLINDER
Volume – cu. ft. (liters)
3.1 (87.8)
Diameter – in. (mm)
21.6 (547)
Depth – in. (mm)
13.4 (341)
DOOR OPENING
In. (mm)
14.2 (361)
WASH SPEED
RPM
31-40
EXTRACT SPEED
Maximum rpm
800
Maximum g-force
214
OPERATING  PRESSURE
Psi (bar)
20-100 (1-8)
INLET  HOSE
Ft. (m)
4 (1.22)
DRAIN  HOSE
Ft. (m)
6 (1.83)
ADJUSTABLE LEVELING LEGS
APPROXIMATE WEIGHT
Crated — lbs. (kg)
254 (115)
Uncrated — lbs. (kg)
245 (111)
DIMENSIONS
Width — in. (mm)
27 (685.8)
Depth — in. (mm)
29 (736.6)
Height — in. (mm)
44.80 (1137.92)*
* Height at metercase top does not include pedestal.
**Average based on J1 testing with factory installed preset cycles.
See specific instructions for proper installation. Because of continuous product improvement, Whirlpool reserves the 
right to change specifications without notice.
Pedestal Single Box Kit #WHP0400VW 
Pedestal Pack of 10 Kit #WHP0401VW
Dimensions are for planning purposes only. 
See Whirlpool® Installation Instructions for full details.
3 YEARS LIMITED PARTS 
ONLY WARRANTY
For a period from the date of original purchase through 
the time listed above, the designated parts that fail in 
normal commercial use will be repaired or replaced free 
of charge for the part itself, with the owner paying all 
other costs, including labor, transportation and customs 
duty. Chemical damage is excluded from all warranty 
coverage. See complete warranty for details.
Whirlpool® Front-Load Washer 
MICROPROCESSOR CONTROLS
To Locate a Distributor Near You, Please Visit www.whirlpoolcommerciallaundry.com/distributor,  or call 1-800-NO-BELTS
Exhaust Information 
All dryers require the equivalent of a 4-inch diameter exhaust 
duct. Rigid metal duct is recommended. Failure to properly 
exhaust the dryer will result in improper operation.
# of 90° turns
4" Hood
1
2
" Hood
Maximum length of 4" diameter rigid metal duct
0
64 Ft.
58 Ft.
1
54 Ft.
48 Ft.
2
44 Ft.
38 Ft.
3
35 Ft.
29 Ft.
4
27 Ft.
21 Ft.
Maximum length of 4" diameter flexible metal duct
0
36 Ft.
28 Ft.
1
31 Ft.
23 Ft.
2
27 Ft.
19 Ft.
3
25 Ft.
17 Ft.
4
23 Ft.
15 Ft.
NON-METERED
COMMERCIAL DRYERS