CRU DataPort 5+ 9275-141-05 Leaflet

1 - DataPort frame assembly

1 - DataPort carrier assembly

2 - Metal covers

4 - 6 x 32 x 3/8” flat-head screws for hard drive mounting

4 - M3 x 10mm Phillips pan-head screws for frame mounting

2 - Keys for lock

1 - Cover removal tool

1.  Turn off the computer and disconnect the power cord from the 

electrical outlet.  Before working on the computer, wait one 

minute for any residual energy to dissipate.  Ground yourself 

by touching the chassis of the computer.

2.  Locate an available 5.25” drive bay with external access.  Re-

move the cover of the computer.  Identify the 5.25” half-height  

bay in which the DataPort frame assembly will be mounted. 

Examine the bay to determine the location of mounting holes 

or whether mounting rails are required. Remove any filler 

plates that may be present on the computer.

3.  Rail mounting the frame. If the drive bay requires mounting 

rails, install one on each side of the frame. The mounting rails  

should be provided with the computer system. 

4.  Direct mounting the frame. Slide the frame into the 5.25” bay,  

some computer bezels will not allow the frame to be inserted 

from the front.  Install the frame from inside the computer.  

Secure the frame with the screws provided.  

5.  Connect the DC power cable to the frame. Locate an available  

4-pin DC power cable from the computer power supply and 

plug it into the receptacle on the frame.

6.  Connect the data cable to the frame. Locate an available SCSI  

connector on the SCSI cable and connect it to the data connec-

tor on the frame.

The frame installation is now complete; follow the instruc-

tions below for carrier installation.

1.  Remove the carrier’s top and bottom covers. The metal covers  

for the DataPort carrier are snapped into place on the carrier  

without any screws. Use the supplied cover removal tool or a  

small flat head screwdriver for this task.

2.  Connect the SCSI ID selector switch to the SCSI ID selector    

header on the hard drive.  See Connecting the SCSI ID Selector  

Switch section in the Operation section for more details.

3.  Plug the 4-pin DC power cable into the power connector on the  

hard drive and ensure it is fully seated.

4.  Connect the data cable in the carrier to the hard drive for 50-  

pin and 68-pin SCSI drives.  For SCA drives connect the hard   

drive to the connector on the circuit board.

5.  Place the drive in the carrier and use the four screws provided  

to side-mount the hard drive. Position the cables inside the  

carrier assembly so that they are completely enclosed within  

the carrier. For DataPort 5+ and 6, attach the Temperature  

Control Cooling Sensor (TCCS) to the top of the hard drive with  

an adhesive strip (or a piece of tape).  Replace the top and bot-

tom covers on the carrier.

6.  Position the carrier on the frame’s guide rails and slide the    

carrier in. Using thumb pressure, fully seat the carrier in the   

frame and lock the carrier with the keylock.  The installation is 

complete and the DataPort is ready for operation.