Premier BFK5S9XP Manual
BEFORE YOU CALL FOR SERVICE
Before you call for service, review this list. It may save you time and expense. This list includes common oc-
currences that are not the result of defective workmanship or materials in this appliances.
currences that are not the result of defective workmanship or materials in this appliances.
Find your problem here
SURFACE BURNERS
SURFACE BURNERS
Surface burners do not light.
Flame burns half-way around
Flame is orange.
Flame burns half-way around
Flame is orange.
Possible cause
Range power cord is disconnected
from the outlet.
Electrical power outage.
Batteries dead, missing or im-
properly installed.
Surface control has not been com-
pletely turned to the LITE or
START position.
Burner ports are clogged.
Burner ports are clogged.
Moisture is present after cleaning.
Range improperly converted.
from the outlet.
Electrical power outage.
Batteries dead, missing or im-
properly installed.
Surface control has not been com-
pletely turned to the LITE or
START position.
Burner ports are clogged.
Burner ports are clogged.
Moisture is present after cleaning.
Range improperly converted.
How to fix it
Be sure power cord is plugged into
grounded outlet.
Burners can be lit manually. See
“Operating your range during an
electrical power failure” section.
Check that the range power pack
has fresh batteries and that they are
installed as described on the bat-
tery pack.
Push in and turn control to the
LITE or START position until
burner ignites, then turn control to
desired flame setting.
Use a small gauge wire or needle
to open ports or clear slotted ports.
Use a small gauge wire or needle
to open ports or clear slotted ports.
Lightly fan the flame and allow
burner to operate until flame is
full.
Dry burners thoroughly following
instructions in range “Cleaning”
section.
Correct conversion by following
instructions on Pages 22-24 in this
manual.
grounded outlet.
Burners can be lit manually. See
“Operating your range during an
electrical power failure” section.
Check that the range power pack
has fresh batteries and that they are
installed as described on the bat-
tery pack.
Push in and turn control to the
LITE or START position until
burner ignites, then turn control to
desired flame setting.
Use a small gauge wire or needle
to open ports or clear slotted ports.
Use a small gauge wire or needle
to open ports or clear slotted ports.
Lightly fan the flame and allow
burner to operate until flame is
full.
Dry burners thoroughly following
instructions in range “Cleaning”
section.
Correct conversion by following
instructions on Pages 22-24 in this
manual.
27