Asko T884XLHPW Owner's Manual

16

Customer Care Center, 1-800-898-1879, www.askona.com

INSTALLATION

See the separate installation instructions included in the 

set of documents.

ELECTRICAL INSTALLATION

Connect the machine by plugging it into an earthed wall 

socket. The electrical wall socket must be placed outside 

of the installation area to be easily accessible. 

CONNECTION ON DELIVERY

•  208-240 V, 1-phase, 15 A
•  60 Hz
•  Heat output 3000 W
•  Use a type A residual-current device.

SWITCH-OVER

The switchover must be performed by a qualified 

electrician.
1.  The switchover must be performed by a qualified 

electrician.

2.  Press and hold the Temperature selection button and 

then press the main power switch.

3.  Turn the programme selector and choose between: 

Heater 2 On (3000 W/15 A) and Heater 2 Off (1950 

W/10 A). 

4.  Press the Start button once to save your selection.

Risk of fire.
Install the clothes dryer according to the manufacturer’s 

instructions and local codes.
Do not install a clothes dryer with flexible plastic 

venting materials. If flexible metal (foil type) duct is 

installed, it must be of a specific type identified by 

the applience manufacturer that is UL approved for 

use with clothes dryers. Flexible venting materials are 

known to collapse, be easily crushed, and trap lint. 

These conditions will obstruct clothes dryer airflow and 

increase the risk of fire.
To reduce the risk of of severe injury or death, follow all 

installation instructions.
SAVE THESE INSTRUCTIONS FOR FUTURE 

REFERENCE.

POSITIONING THE TUMBLE DRYER

The tumble dryer can be freestanding or stacked. 

Remember that the tumble dryer produces heat and 

should therefore not be located in a room that is too small. 

If the room is very small, drying will take longer due to the 

limited quantity of air.

•  Clothes dryer installation must be performed by a 

qualified installer.

•  For proper ventilation, the machine should not be 

installed behind a door.

•  The tumble dryer’s toe kick ventilation must not be 

blocked by a rug or the like.

NOTE!
If the unit must be installed behind a door, the door 

should be louvered. (please see door ventilation 

requirements in the Built-in chapter). To improve 

ventilation, the door where the tumble dryer is located 

should be left open when the dryer is in use.

The tumble dryer can be positioned beside the washing 

machine.

The tumble dryer can be placed on top of a ASKO 

washing machine. In this case you use the stacking 

attachments (foot cups and anti-tilt devices) that come 

with the machine. Two rubber feet and two anti-tipping 

brackets are supplied in the bag found in the drum of the 

dryer.

INSTALLATION