Asko T884XLHPW Owner's Manual
19
Customer Care Center, 1-800-898-1879, www.askona.com
INSTALLATION
NOTE!
When installing in warm climates (77° F and above)
When installing in warm climates (77° F and above)
with high humidity levels, do not route the air exhaust
duct upwards.
subtract 4 feet for
every 90°elbow
Examples of
installations
TO CONNECT THE EXHAUST DUCT TO
A VENTILATION OUTLET, FOLLOW THE
STEPS BELOW:
1. Connect the exhaust duct to a ventilation exhaust
fitting or to a discharge through the wall.
2. Secure the duct joint to the outlet stub on the
machine.
3. Run the duct with as few bends as possible to the
point of discharge.
subtract 4 feet for
every 90°elbow
WARNING !
This appliance shall not be exhausted into a chimney,
a wall, a ceiling, an attic, a crawl space or a concealed
space of a building. Only a rigid or flexible metal duct
shall be used for exhausting. Only a metal ventilation
grill shall be used. If the duct is taken to a wall outlet, a
ventilation grill shall be fitted to prevent reverse flow of
cold air. Fit the ventilation grill to the outside of the wall.
ELECTRICAL INSTALLATION
WARNING !
The receptacle on the rear of the machine is designed
to accommodate ASKO washers ONLY (rated 208–240
V.) To use this receptacle, you must use the ready-
fitted plug supplied with the washing machine or an
equivalent.
ASKO washers rated 208–240 V have two internal
ASKO washers rated 208–240 V have two internal
fuses of 15 A each.
The machine should only be connected to a grounded
The machine should only be connected to a grounded
wall socket.
WARNING !
This appliance must be properly grounded. Refer
to the “Important Safety Instructions” for grounding
instructions.
The power supply cord must be grounded. If the
The power supply cord must be grounded. If the
machine is to be used in a wet area, the supply must be
protected by a residual current device.
Connection to a permanently wired supply point must
Connection to a permanently wired supply point must
be made only by a qualified electrician. As supplied:
Single-phase, 230 V, 60 Hz, 3000W heater rating 30 A
circuit required - only a power-supply cord kit rated 230
V min, 30 A, and marked for use with clothes dryers
shall be used.
Remove cover to access
teminal box. (Requires- Torx
screwdriver.)