Bosch HMVP052U Installation Instruction

12

Gently remove the wires from the grooves. Reroute the 

wires through the grooves on other side of the blower 

unit. Rotate blower unit 90º so that fan blade openings 

are facing out the back of the microwave.

9

Do not pull or stretch the blower unit wiring. Make 

sure the wires are not pinched, and that they are 

properly secured.

Place the blower unit back into the opening.

Replace the blower plate and secure with the screws 

removed in Step 1.

Attach the exhaust adapter to the rear of the oven by 

sliding it into the guides. Push in securely until it is in 

the lower locking tabs. Make sure the damper hinge 

swings freely.

Remove power to outlet.

Remove all contents from upper cabinet.

Tape the TOP CABINET TEMPLATE onto the bottom 

surface. Make sure the template centerline aligns with 

the vertical line on the wall. Rear wall arrows must be 

against rear wall.
Note:  For recessed cabinet bottom, trim the template 

edges so that it fits inside the recessed area. The 

template has trim lines to use as guides.

Drill 3\8" (10 mm) holes at "A", "B" and "C".
Note:  Wear safety goggles when drilling holes in the 

cabinet bottom.

Cut out the 2" (51 mm) hole at "D". This hole is for the 

power supply cord.
Note:  If the cabinet is metal, use the nylon grommet 

around the opening to protect the cord.

Roof venting installation only: Cut out the shaded 

area "E" on the TOP CABINET TEMPLATE using a 

saber or keyhole saw.

Remove templates from back wall and cabinet.

▯

If the bottom of the upper cabinet is recessed or has 

front overhang, you will need to prepare 2" x 2" (51 

mm x 51 mm - depth equivalent to cabinet recess or 

overhang) filler blocks to provide additional support for 

the bolts:

▯

mark the center of each filler block and drill a 3\8" 

(10 mm) diameter hole

▯

align filler blocks over the three openings on top of 

the microwave oven and attach with masking tape

▯

Use at least two people to install the microwave oven. 

Do not grip or use handle during the installation.

▯

When mounting the microwave oven, thread power 

cord through hole in bottom of top cabinet. Keep the 

cord tight and do not pinch it, especially when 

mounting flush to bottom of cabinet. Do not pull the 

cord to lift the oven.