Bosch HEIP054U Manual

Page of 88
English 35
To replace the oven door:
Warming Drawer Maintenance
Removing the Drawer
1. Pull drawer to fully open position.
2. Press down right drawer clip.
3. Lift up left drawer clip.
4. Firmly pull the drawer straight out. Retract cabinet rails 
while drawer is removed.
Replacing the Drawer
1. Be sure cabinet rails are pushed inside cabinet.
2. Align the drawer rails with the cabinet rails.
3. Firmly push the drawer straight into the cabinet until 
drawer clicks into place.
4. Open and close drawer to test operation. Note: if the 
drawer will not close, verify that the rail clips are 
properly positioned.
1. Holding the door firmly 
in both hands, place 
hinges in hinge slots.
2. Catch the small slot at 
the base of the hinge 
(A) in the bottom of the 
hinge slot (B) in the 
oven body. Then tilt 
the door inward and 
slide the hinges into 
place. The door 
should catch at this 
point and remain firmly 
attached to the oven 
body.
3. Open the door all the 
way to expose the 
hinges and slots.
4. Push both hinge 
levers down and away 
from you until flush 
with the face of the 
oven body.
5. Close and open door 
slowly to be sure it is 
correctly and securely 
in place. Door must be 
straight, not crooked.
CAUTION
To prevent burns, do not remove drawer while hot. 
Be sure drawer is empty before removing.
LOW
HIGH
_
MED
PROO
F
+
ON/OFF