Bosch HDIP054U Manual

English 11

The rack is designed with a stop so it will stop before 
coming completely out of the oven and not tilt. 

To insert the flat rack into the oven:

1. Grasp rack firmly on both sides.
2. Insert rack (see picture).

3. Tilt rack up (A) to allow the upwardly sloped rear of the 

rack to slide under the stop molded into the front 
portion of the rack guide above.

4. When the back of the rack is past this stop, lower the 

front of the rack to a horizontal position (B) and push it 
the rest of the way in.
The rack should be straight and flat, not crooked.

To remove the flat rack from the oven:

1. Grasp rack firmly on both sides and pull rack toward 

you.

2. When the stop is reached, tilt rack up so that the 

upwardly sloped back of the rack can pass under the 
stop. Pull the rack the rest of the way out.

1. Slide the rack in evenly until the rear of the rack is 

about 2 inches from the back of the oven.

2. Tilt the front of the rack up about 3/4’s of an inch (A) 

and finish pushing the rack all the way back (B)
Note: Avoid striking the oven light cover glass when 
pushing the rack into position.

3. The back of the telescopic rack drops into place.
4. Pull the rack forward to engage the bottom of the rack 

onto the rear of the rack position guide.

5. Lower the front of the rack to finish seating it on the 

rack guide. The rack should feel stable when properly 
seated.

6. Slide the movable part of the telescopic rack in and out 

a few times to make sure it is able to move freely and 
that the non-moving part of the telescopic rack is 
securely anchored.

1. Lift the front of the telescopic rack assembly about 1/2 

inch and push the rack to the rear about 3/4 inch. This 
allows the rack to disengage from the rack position 
guide.

2. Lift the rear of the telescopic rack assembly so it clears 

the rack position guide and gently pull the rack from the 
oven.

9 CAUTION

To avoid burns, place oven racks in desired 
positions before turning oven on. Always use oven 
mitts when the oven is warm. If a rack must be 
moved while the oven is hot, do not let oven mitts 
contact hot heating elements.

Use caution when removing an oven rack from the 
lowest rack position to avoid contact with the hot 
oven door.

To avoid possible injury or damage to the appliance, 
ensure racks are installed exactly per installation 
instructions and not backwards or upside down.

9 CAUTION

To avoid possible injury or damage to the appliance, 
ensure the telescopic rack is installed exactly per 
installation instructions and not backwards or upside 
down.