Bosch HDIP054U Manual

Page of 104
English 18
The fast preheat icon
&
appears in the display just 
above the mode name.
2. Press Start.
Fast Preheat can be turned off by pressing Fast Preheat 
again.
Special Features
The special features provide you with additional 
conveniences when cooking.
Learn more about these special features in the following 
sections:
Probe (some models)
Sabbath Mode
Panel Lock 
Probe (some models)
The probe measures the internal temperature of the food. 
The probe is available for Bake, Roast and all convection 
cooking modes except Convection Broil.
Inserting the probe:
Insert the tip of the probe in the middle and thickest part of 
the meat. Make sure the probe is not touching fat, bone, or 
parts of the oven or the pan.
To use the probe:
1. Insert the probe into the meat as described above.
2. Connect the probe to the oven. If the probe is not 
connected to the oven prior to starting Probe mode, an 
error tone sounds and the message “INSERT PROBE” 
is displayed.
3. The Set Probe Temp screen is displayed. A three digit 
input prompt “- - -” blinks in the lower right corner. Use 
the numeric keypad to enter the desired probe 
temperature and press Enter on the numeric keypad.
4. Set the cooking mode and temperature.
Note: The minimum probe temperature that can be set 
is 100° F (40° C) and the maximum is 200° F (100° C). 
If the probe temperature entered is outside this range, 
an error is displayed.
5. The probe current temperature and target temperature 
are both displayed in the format “105 / 180” at the lower 
right corner of the display. The actual temperature will 
display < 80 until the food temperature reaches 80³ F.
The displayed probe temperature is updated in 
increments of 5° during the cooking process.
6. When the probe temperature reaches the set 
temperature, the cooking mode turns off. The current 
time is displayed and the message “COOKING 
COMPLETE” blinks at the bottom left of the display. An 
alarm tone sounds every 10 seconds for 2 minutes.
This screen remains in the display until it is cleared by 
pressing the Oven Clear/Off touchpad or until the 
probe is removed. The display then goes back to stand 
by mode.
Note:
Probe is not available when an Oven Timer has been 
set.
To change the probe temperature press the Probe 
touchpad. The display enters probe temperature 
editing mode and displays the message “SET PROBE 
TEMP”.  Enter the new probe temperature and press 
Enter to accept the new value.
Do not store the probe in the oven.
Always use the handle of the probe for inserting and 
removing.
Always use a potholder to remove the probe since it 
becomes hot.