Bosch HBL5651UC Instruction Manual

Page of 20
English 5
Remove Safety Cap before Using 
Probe
Some models include a temperature probe used  to sense 
internal tempererature of meats during cooking.
The probe ships with a black plastic safety cap over the 
pointed metal end of the probe. The cap must be removed 
prior to use.
.
Side Hinge Door Opening/Closing Troubleshooting Guide
Primary observation
Additional observations
Cause:
Solution
The door does not pull 
itself closed and feels 
difficult to open as well.  
 
The side edge of the inner 
door (on the handle side of 
the door) appears to make 
contact with the unit's side 
trim.
The installation is 
causing the side 
trim to be pushed 
too far inwards.
Check the installation of the unit in the 
cabinetry.  Try to move the unit in the cabinet 
towards the side of the hinges as much as 
possible to allow the interfering side trim to 
open up.
May also try to adjust the location of the side 
trim screws to hold the trim away from the 
door.  
Check again the cabinet opening to ensure 
that it is not too narrow.  Widen the cutout as 
necessary.
The door does not hold 
itself closed.   
Very little force is required 
to pull open the door.
The door catch 
mechanism 
internal to the 
door has 
inadvertently 
tripped while the 
door was open.   
To reset the mechanism, close the door 
completely and while closed, push in firmly on 
the door handle until the mechanism resets. 
A firm push may be required.  Open to test.
The door does not close 
onto the striker 
smoothly.
Once closed, the door 
opens without incident.
When closing the door onto 
the striker, the door lifts 
itself upwards.  
You will feel a slight bump 
as the roller (internal to the 
door) hits the tip of the 
striker and lifts the door.
If the door needs to lift 
substantially, the door will 
no longer pull itself closed, 
and assistance is required 
to push it closed fully.
The door 
alignment is too 
low to engage 
properly with the 
striker.
See figure B in the 
side hinge door 
alignment 
instructions.
Refer to the side hinge door alignment 
procedure to raise the handle side of the door 
until the door closes smoothly.
It should open smoothly and pull itself closed 
smoothly without hearing or feeling an 
interference.
The door does not close 
onto the striker 
smoothly.
Once closed, the door 
may also appear to 
stick while pulling the 
door open
While trying to open the 
door from a closed position, 
you feel an interference that 
catches the door and may 
prevent it from opening.   
You feel a similar 
interference when closing.
The door 
alignment is too 
high to engage 
properly with the 
striker.
See figure A in the 
side hinge door 
alignment 
instructions.
To open a sticking door, apply pressure 
downward on the handle while pulling.
Refer to the side hinge door alignment 
procedure to lower the handle side of the door 
until the door closes smoothly.
It should open smoothly and pull itself closed 
smoothly without hearing or feeling an 
interference.