Bosch HMV8052U Installation Instruction

Page of 32
9
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
4
I
M
P
O
R
T
A
N
T
 
S
A
F
E
T
Y
 
I
N
S
R
E
A
D
 
A
N
D
 
S
A
V
E
 
T
H
E
S
E
 
I
N
S
T
R
U
C
T
I
O
N
S
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE 
APPLIANCE AFTER INSTALLATION IS COMPLETE.  
IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE 
LOCAL ELECTRICAL INSPECTOR'S USE.
WARNING
If the information in this manual is not followed exactly, 
fire or shock may result causing property damage or 
personal injury.
WARNING
Do not repair, replace or remove any part of the 
appliance unless specifically recommended in the 
manuals. Improper installation, service or maintenance 
can cause injury or property damage. Refer to this 
manual for guidance. All other servicing should be done 
by a qualified technician.
Appliance Handling Safety
Unit is heavy and requires at least two people or proper 
equipment to move. 
Do not lift appliance by door handle.
Hidden surfaces may have sharp edges. Use caution 
when reaching behind or under appliance.
Safety Codes and Standards
This appliance complies with the latest version of one or 
more of the following standards:
CAN/CSA C22.2 No. 61 - Household Cooking Ranges
UL 858 - Household Electric Ranges
CAN/CSA C22.2 No. 150 - Microwave Ovens
UL 923 - Microwave Cooking Appliances
UL 507 - Electric Fans
CAN/CSA C22.2 No. 113 - Fans and Ventilators
CSA C22.2 No. 64 - Household Cooking and Liquid-
Heating Appliances
UL 1026 - Electric Household Cooking and Food 
Serving Appliances
It is the responsibility of the owner and the installer to 
determine if additional requirements and/or standards 
apply to specific installations.
State of California Proposition 65 
Warnings
WARNING
This product contains chemicals known to the State of 
California to cause cancer, birth defects or other 
reproductive harm.
Electric Safety
WARNING
Before you plug in an electrical cord or turn on power 
supply, make sure all controls are in the OFF position.
For appliances equipped with a cord and plug, do not 
cut or remove the ground prong. It must be plugged into 
a matching grounding type receptacle to avoid electrical 
shock. If there is any doubt as to whether the wall 
receptacle is properly grounded, the customer should 
have it checked by a qualified electrician.
If required by the National Electrical Code (or Canadian 
Electrical Code), this appliance must be installed on a 
separate branch circuit.
Installer – show the owner the location of the circuit 
breaker or fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel. 
Lock service panel to prevent power from being turned 
ON accidentally.
Be sure your appliance is properly installed and 
grounded by a qualified technician. Installation, electrical 
connections and grounding must comply with all 
applicable codes.
Microwave Safety
PRECAUTIONS TO BE OBSERVED BEFORE AND 
DURING SERVICING TO AVOID POSSIBLE EXPOSURE 
TO EXCESSIVE MICROWAVE ENERGY 
Do not operate or allow the oven to be operated with 
the door open.
Make the following safety checks on all ovens to be 
serviced before activating the magnetron or other 
microwave source, and make repairs as necessary: 
1.
Interlock operation 
2.
Proper door closing 
3.
Seal and sealing surfaces (arcing, wear, and other 
damage)
4.
Damage to or loosening of hinges and latches 
5.
Evidence of dropping or abuse
Before turning on microwave power for any service 
test or inspection within the microwave generating 
compartments, check the magnetron, wave guide or 
transmission line, and cavity for proper alignment, 
integrity, and connection.
Any defective or misadjusted components in the 
interlock, monitor, door seal, and microwave 
generation and transmission systems shall be 
repaired, replaced, or adjusted by procedures 
described in this manual before the oven is released 
to the owner.
A microwave leakage check to verify compliance with 
the Federal Performance Standard should be 
performed on each oven prior to release to the owner.