Bosch NET8666SUC Manual

16

If you encounter a problem, it often will merely be 

something minor. Before you call customer service, 

consider the suggestions and instructions below:

9

Repairs should only be done by a trained servicer.
Improper repair of your appliance may result in risk 

of severe physical injury or death.

--------

Cooktop is not working The electric power supply has been 

interrupted.

Use other electrical appliances to check if there has 

been a power outage. Check to see if there is a prob-

lem with the circuit breaker for the electrical installa-

tion.

The appliance has not been cor-

rectly connected following the con-

nection diagram.

Make sure that the appliance has been connected cor-

rectly.

Electronic system malfunction.

Contact the Technical Assistance Service.

“

 is flashing on the ele-

ment display

The touch control zone is wet, very 

dirty, food has boiled over, or an 

object is lying on top of the touch 

control zone.

Clean the touch control zone, or remove the object. 

Lightly touch the corresponding touch key. The flash-

ing should stop.

“

 flashes on all ele-

ment displays.  An 

accoustic signal 

sounds

The main switch has been activated 

continuously for more than 5 sec-

onds.

Press the power key again. Reset the cooktop.

The cooktop turns off 

by itself

The main switch has been touched 

unintentionally.

Press the main switch again. Reset the cooktop.

Display 

“

 and numbers A fault in the electronic system has 

occurred.

Turn the appliance off and back on at the fuse or cir-

cuit breaker.  If the same fault occurs again, discon-

nect the appliance and call Technical Assistance 

Service.

Display 

”

 and numbers A fault has been detected.

The following table of error messages lists actions you 

can take to correct the problem

”ƒ

The element is too hot and has 

turned off.

Remove the pans from the elements. 

”ƒ

 disappears 

when you press the display, if the element has 

cooled down sufficiently. Wait a few minutes until the 

element has cooled down a bit. If 

”ƒ

 appears again 

after the element is turned back on, the cooktop is 

still too hot. Turn off the elements and allow them to 

cool further.

”…

The touch control zone is too hot.

Make sure that cookware is properly positioned on 

the element, and no hot objects are in contact with 

the touch control zone. Wait a few minutes until the 

touch control zone has cooled down. If 

”…

 appears 

after you turn on the appliance, call Technical Assis-

tance Service.

”‰

The element was in continuous use 

for too long.

The automatic time limitation has been activated. 

Touch any key. You can now turn on the heating ele-

ment immediately.