Verona VECTGM424SS Installation Instruction

 

 

9

Before installing apply the foam tape. 

A tape is provided to seal the cooktop edges to the 

countertop. Apply tape near inner underside cooktop 

edge. 

Use tape around the entire cooktop perimeter. 

Cut off excess where tape butt ends. 

 

Insert the cooktop centered into the cutout opening. 

Make sure the front edge of the counter top is parallel 

to the cooktop. Make final check that all required 

clearances are met. 

 

Four clamp brackets are provided with your unit. 

After cooktop has been installed into the countertop, 

install the brackets on the burner box as shown in fig-

ure 9. 

Install the clamp brackets on the front and back of the 

burner box bottom (if the cabinet construction does 

not provide clearance for installing brackets at the 

burner box front back install the clamp brackets on the 

lateral position of burner box). 
step A place the clamping screws into brackets 
step B attach brackets by using the attachment 

screws on the selected location of burner box, tighten 

screws just enough to hold  brackets in place 
step C position brackets so that they are with the 

clamp screw in contact with the counter top bottom 
step D tighten attachment screws securely. 
step E check that the front edge of the cooktop is 

parallel to the front edge of the countertop tighten the 

screw clamping against the countertop. 
DO NOT OVER TIGHTEN