BlueStar RGTNB364CFTBV2NG Installation Instruction



As part of the installation protective plas-
tic wrappers on stainless steel surfaces 
should be removed.  These wrappers must 
be removed before operation. 



New appliances are wiped clean with vari-
ous cleaners and solvents to remove visi-
ble signs of dirt, oil and grease before 
leaving the factory.  After installation, 
performance checks and adjustments, the 
appliance should be allowed to heat to 
burn off any such oils from internal parts.  
The presence of such coatings is normal 
as part of the manufacturing process.  The 
ventilation hood should be turned on and 
the area well ventilated to allow fumes to 
escape safely. 



Removable parts should be washed with 
hot soapy water, well rinsed and wiped 
dry.

 



Complete and mail your Performance 
Checklist to validate your warranty.

 

 



Remove the top grates and thoroughly 
wash them with hot soapy water, rinse and 
wipe dry.  Extended exposure to moisture 
may cause these cast parts to rust. 



To light a burner turn the corresponding 
control knob to HIGH. 



This knob is a gas control valve and an 
electric switch.  Turning to the High posi-
tion begins the ignition sequence. 



The igniters begin to “click”.  As gas 
flows through the piping to the burner the 
sparking ignites it. After the flame lights 
the igniter senses its heat and the 
“clicking” automatically stops. 



ALL burners light at the HIGH setting. 



Burners are equipped with a re-ignite fea-
ture in case the flame is extinguished for 
any reason. 



At the High setting, flames should be 

sharp with blue tips.  Some yellow may 
appear depending on the type of gas being 
burned. 



Turn the flame lower so it does not wrap 
around the bottom edge of the pan. 



Burners may be operated at any knob po-
sition between LOW and HIGH. 



Never operate the burner with the knob 
between  the HIGH and OFF position.  If 
the flame goes out it will not re-ignite and 
gas leaks could occur. 



When you turn the valve off the flame 
may linger several seconds until all the 
gas in the feeder tube is burned up. 



Turn off the burner from a low setting to 
avoid popping of the burner.   



Place a pot or pan on top of the burner 
before turning on the burner for ideal igni-
tion 

 
GRIDDLES 



New griddles must be seasoned prior to 
their first use. 



Remove all factory materials and wash the 
griddle plate with hot soapy water.  Rinse 
and dry thoroughly. 



Apply a light coating of unsalted peanut 
oil to the top, sides and front of the grid-
dle plate.  Wipe away any excess oil. 



To light the burner turn the knob counter 
clockwise to the medium setting. 



When the griddle is lit turn the heat set-
ting back to “LOW”. 



After a short while as the griddle heats it 
likely will discolor with the heat.  Colors 
range through different shades of blue and 
black.  This is a normal characteristic of 

                                   RGTNB 2011-REV1