Smeg A1PXU User Manual
Instructions for the user
30
10.SPECIAL MAINTENANCE
The oven may require special maintenance or replacement of parts subject to wear such as gaskets,
bulbs, etc. The following instructions describe how to perform these minor maintenance operations.
bulbs, etc. The following instructions describe how to perform these minor maintenance operations.
WARNING
ELECTRICAL SHOCK HAZARD
Before servicing, disconnect the appliance from the power supply.
10.1 Removing the door
Open the door completely.
Insert a pin in the hole in the
hinge. Repeat this operation on
both hinges.
Insert a pin in the hole in the
hinge. Repeat this operation on
both hinges.
Grasp the door on both sides
with both hands, lift it forming an
angle of about 30° and remove it.
with both hands, lift it forming an
angle of about 30° and remove it.
To reassemble the door, put the
hinges in the relevant slots in the
oven, making sure that grooved
sections A are resting completely
at the bottom of the slots. Lower
the door and once it is in place
remove the pins from the holes in
the hinges.
hinges in the relevant slots in the
oven, making sure that grooved
sections A are resting completely
at the bottom of the slots. Lower
the door and once it is in place
remove the pins from the holes in
the hinges.
10.2 Replacing the oven light bulb
Remove the bulb protector A by turning it anticlockwise and replace
bulb B with a similar one. Re-fit bulb protector A.
bulb B with a similar one. Re-fit bulb protector A.
NOTE: Use only oven bulbs (T 600°F).
10.3 Lubricating the surface burner gas valves
Over time, the surface burner gas valves may become stiff or jam. Clean them
internally and relubricate. This operation must be carried out by a qualified
technician.
internally and relubricate. This operation must be carried out by a qualified
technician.