Broan 359NDK Installation Instruction
10¼"
L
C
4¼"
SOFFIT
HOOD
CENTER LINE
90
0
ANGLE
BOOT
(included)
(included)
NON-DUCTED FILTERS
(99010374)
LINER
(LB30, LB36,
LT30, or LT36)
25"
SOFFIT
CUTOUT
6" ROUND
TO 7” ROUND
TRANSITION
(included)
(purchase
separately)
1. Install PM500 per installation instructions shipped with power module.
2. Remove aluminum filters and attach
2. Remove aluminum filters and attach
non-ducted filters furnished with kit. Refer to installation
instructions provided with filters.
3. Remove backdraft damper. (Damper supplied with power module.)
4. Install the 6” round to 7” round
4. Install the 6” round to 7” round
transition over exhaust of unit.
5. Connect
7” round duct to transition.
6. Cut hole in bottom of
soffit to allow clearance for the 90
0
angle boot.
7. Locate center of
4¼” x 10¼” opening on soffit - at horizontal centerline of hood and 25” above
top of
liner.
8. Layout 4¼” x 10¼” pattern and cut opening in soffit.
9. Insert 90
9. Insert 90
0
angle boot into soffit opening and connect boot to 7” round duct.
10. Install
grille (included) into soffit opening.
11. Use duct tape to make all connections secure and air tight.
Broan-NuTone LLC Hartford, Wisconsin www.broan.com 800-558-1711
Broan-NuTone Canada Mississauga, Ontario www.broan.ca 877-896-1119
Broan-NuTone Canada Mississauga, Ontario www.broan.ca 877-896-1119
99045562A
INSTALLATION INSTRUCTIONS
359NDK DUCTLESS CONVERSION KIT FOR THRU SOFFIT VENTING
FOR USE WITH PM500 POWER MODULE